. MCDI distributors on the www
Products Guidego to download sectiondisplay contacts and general infosee our distributors on the www
.
go to dutch main page Description

MCDI-TLR is a high performance twin-line alarm receiver card for PC computers.
TLR can be installed in any standard chassis IBM™ or compatible PC - AT, 386, 486 or Pentium™. TLR can interface up to two telephone lines. Imposes no limit onto the number of customers per line, and provides a DB25 parallel printer port. Output to printer does not go through PC.
TLR automatically adjust to a wide variety of protocols ranging from 3x1 to Contact ID.
With external battery support and memory buffer TLR can go on operating even if PC has failed.
FCC (USA), IC (Canada) and CE (Europe) certified.
go to deutsch distributors page
home page
TLR ESPANOL
SPECIFICATIONS TLR
TLR PORTUGUES
go to chinese main page
home page
Specifications
Communications:

TLR provides an RJ11 type phone jack for connection to 1 or 2 telephone lines.
Type : Pulse, DTMF
Reception Speed : 10, 20, 40 pps (Dual Round or Checksum)
Handshake and Kiss-off : 1400Hz / 2300Hz
Pulse Frequency : 1800Hz / 1900Hz

Reporting Formats supported:

Acron Radionics 6500
Ademco: Radionics extended
- Slow/Fast; Sescoa Slow
- Contact ID; Sescoa Standard
- Extended; SurGard
- Express; Contact ID
- High Speed - compressed & converted
FBI Super Fast Silent Knight Slow
3x1 3x1 extended
4x1 3x1 extended compressed 4x2
4x1 extended 4x1 extended compressed 4x2
4x2 Zero removed 3x1, 4x1, extended.

Power Requirements:
From computer +12V Supply: 600 mA max.
From 6V Battery (standby): 500 mA

Event logging when PC absent:
When computer is absent TLR can store up to 256 events. Maximum of 155 events in Contact ID. In between for mix protocols
 Printer Output:
- Standard DB25 connector for Centronics Parallel Interface.
- Card linking arrangement allows one printer to serve all TLR receivers in one PC.

Port & IRQ:
Port address and IRQ are selectable by jumpers:
- COM 1, 2, 3,4
- IRQ 2, 3, 4, 5

Battery Backup:
TLR card provides charging and supervision circuitry for an external 6-Volt battery (not supplied).

Charging Voltage 6.7 volts
Charging Current Limit 500 mA

Station Requirements:
- IBM™ or Compatible AT, 386, 486 or Pentium™ computer with Standard chassis, ISA bus, 640Kbytes RAM, unused COM port and DOS Version 3.1 or later
- Printer with Centronics parallel interface and cable with DB25 connector.

Monitoring Software:
TLR interfaces with the Monitoring software in Native mode and Ademco™ 685 emulation mode.

Jumpers define: Receiver number

FAQ ON INTERNAL RECEIVERS
winsamm.com - products - download section - contacts- distributors on the www - warranty- upgrade
dutch - deutsch - english - español - français - português - chinese